AUDAC SX408A Manuel d'utilisateur

PROFESSIONAL AUDIO EQUIPMENT SX408A Active Subwoofer System User Manual & Installation GuideSX408A AUDAC

9 Balanced: Unbalanced: RedShieldTipSleeve 6) Satellite output connections On these euro terminal output connections is the amplified output si

107) POWER switch Use this switch to turn the SX408A on and off. The signal LED lights up green to indicate when the SX408A is powered up. Note:

11 Block Diagram Chapter 3

12 SX408A Set Solutions FESTA 400 4 x WX502 + SX408A Make sure that the WX502 loudspeakers which will be used in combination with the SX408A are

13CONGRESS 400 2 x AXIR + SX408A Make sure that the AXIR design column speakers which will be used in combination with the SX408A are switched to

14Additional Information Crossover: Lowpass: -3dB 120Hz -6dB 146Hz -24dB/Oct Highpass: -3dB 110Hz -6dB 83Hz 12dB/Oct Input impedance

15Personal notes

AUDAC PROFESSIONAL AUDIO EQUIPMENT User Manual & Installation Guide  AUDAC http://www.audac.eu [email protected]

2 INTRODUCTION ...

3 Introduction This section briefly describes the possibilities of the SX408A active subwoofer system. he SX408A is an active powerful tandem porte

4 Environment Do not place this unit in an enclosed environment such as a bookshelf or closet. Ensure that there is adequate ventilation to cool

5 Safety Requirements Always handle the unit with care. Only use a grounded socket outlet and a power cord with grounding plug to plug in the unit.

6 Overview rear panel Chapter 2 2. RJ45 Remote control connection 1. Amplifier indicator LED’s 3. Satellite outputs volume control4. Subwoof

7 Rear panel description 1) Amplifier indicator LED’s There three LED’s monitor the proper working if the integrated amplifier. - Power LED: Whe

8 3) Satellite volume control With this dial, the output level of the satellite channels can be set. The attenuation of the signal can be set betw