DW5066 User Manual & Installation Guide Digital All-In-One Wall Panel www.audac.eu
10Chapter 2Quick start guideThis chapter guides you through the setup process for a basic project where a DW5066 wall panel should be connected to a d
11After the desired address is selected, click the “Set Address” button. A message will start blinking on all the DW5066 wall panels connected in your
12Chapter 3Installing, Connecting & ConfiguringInstallingFor installing the DW5066, two different kinds of flush mount installation boxes are avai
13ConnectingThe DW5066 wall panels should be connected to the PI (Peripheral Interface) ports on the rear side of the system controller with an UTP CA
14 ATTENTION The twisted pair cabling must always be ‘straight’. In case of self made cabling, it must be wired as described in this
15Prog.Vol+-+-Prog.Vol+-+-Connection possibilitiesA wall panel with additional audio input can be connected to every PI port supporting digital audio
16ConfiguringBefore the DW5066 can be operational, the configurations should be made. First of all, an address needs to be assigned and the available
172) The outputs which you want to control with the selected wall panel can be selected by means of the “Controlled Outputs” dropdown list. When selec
185) The microphone input has the possibility to provide +15V phantom power to power condenser microphones. The pantom power can be switched ON and OF
19Chapter 4Using the DW5066When the DW5066 is correctly installed, connected and configured, the wall panel is ready for opera-tion. The standard scre
20When the desired zone is selected, you will proceed to the settings menu for the corresponding zone. Settings such as Volume control, Input signal s
21When “Input” is lit, you can push this button and you will be redirected to the input selection window. This window shows all (configured) input cha
22The latest settings which can be changed to the zones are the two band tone control. The tone control can be activated by selecting the “Bass” and “
23When returning back to the main menu, the latest selectable option is “Settings”. By selecting this option, changes to the settings of the wall pane
24Chapter 5Technical SpecificationsLine input Stereo, RCA input Sensitivity: +8dB / -6dB Signal / Noise: > 95 dB THD+N: <
25Using the DW5066 as local outputAn additional feature of the DW5066 is that it can be used as a local audio output. The signal from a direct output
262) The internal PCB of the DW5066 will be visible. Each of both connectors (RCA or XLR) will have a wire connected to the PCB Board. Depending of wh
274) The connector which is connected to the Line Output connector now will work as a local line audio output. 5) After the modification of the intern
28Notes
3Index Introduction 5 Chapter 1: Overview of DW5066 6 Overview front panel 6 Front panel description 7 Overview rear panel
4
5IntroductionDigital All-In-One Wall PanelThe DW5066 is an All-in-one wall panel designed to work in combination with AUDAC digital matrix systems. Th
6Chapter 1Overview front panelThe front panel of the DW5066 wall panel contains a 2.5” Graphic color LCD display with an unbalanced line input connect
7Front panel descriptionUnbalanced line input An unbalanced stereo audio source can be connected to these RCA connectors, creating an additional local
82.5” Graphic color LCD display This graphical color LCD display gives a clear overview of all the functions and settings of the wall panel. Rotatable
9Overview rear panelThe rear panel of the DW5066 contains an 8 pin connector to connect the wall panel to the matrix system and a jumper which is mean
Commentaires sur ces manuels