WP523User Manual & Installation Guide Remote Wall Mixer for LX523 www.audac.eu
10Chapter 3Installing & ConnectingInstallingFor installing the WP523, two different kinds of flush mount installation boxes are available. The pla
11ConnectingThe WP523 wall panel should be connected to the LX523 speaker system by means of UTP twisted pair cable. The 8-pin Euro-Terminal Block on
12 ATTENTION The twisted pair cabling must always be ‘straight’. In case of self made cabling, it must be wired as described in t
13Chapter 4Technical SpecificationsLine input Stereo, RCA input Sensitivity: +12dB / -6dB Signal / Noise: > 95 dB THD+N:
3Index Introduction 5 Chapter 1: Overview of WP523 6 Overview front panel 6 Front panel description
5IntroductionRemote Wall Mixer for LX523The WP523 is a Remote Wall Mixer which is meant to be used in combination with the LX523 Active Speaker system
6Master Volume ControlUnbalanced line inputBalanced microphone inputPush-lock gain control potentiometer with clipping LEDChapter 1Overview front pane
7Front panel descriptionUnbalanced line inputAn unbalanced stereo audio source can be connected to these RCA connectors.Balanced microphone input A ba
8Overview rear panelThe rear side of the WP523 contains an 8-pin Euro-Terminal Block connector, whereby the wall panel should be connected to the RJ45
9Chapter 2Quick start guideThis chapter guides you through the setup process for a basic setup where a WP523 should be connected to a LX523 loudspeake
Commentaires sur ces manuels