PROFESSIONAL AUDIO EQUIPMENT DPA74/154 Quad Channel Class-D Amplifier User Manual & Installation GuideDPA74/154 AUDAC
9 The signal sources should only be connected to the balanced XLR connectors of Channel 1 and Channel 3. For more information about how the louds
10Output connections The loudspeaker connections for every output channel are performed with a two pin Euro-Terminal block connector. Stereo Mode:
111) Bridge mono Mode: When the amplifier is switched in bridge mode, there will be one load connected to two amplifier outputs. This load should b
12Block Diagram Chapter 4
13Additional Information Technical specifications Chapter 5 DPA74 DPA154 Performance Rated power (1 kHz, THD 1%) Stereo @ 8 Ohm
14Personal notes
AUDAC PROFESSIONAL AUDIO EQUIPMENT User Manual & Installation Guide AUDAC http://www.audac.eu [email protected]
2 INTRODUCTION ...
3 Introduction This section briefly describes the possibilities of the DPA74/154 Class-D Power Amplifiers. he DPA series amplifiers are digital pow
4 Environment Do not place this unit in an enclosed environment such as a bookshelf or closet. Ensure that there is adequate ventilation to cool
5 Safety Requirements Always handle the unit with care. Only use a grounded socket outlet and a power cord with grounding plug to plug in the unit.
6 Overview front and rear panel Front panel overview Description 1. Power switch: By means of the power switch, the amplifier can be turned ON
7 Rear panel overview Description 4. Power inlet: The mains power supply (100~240V AC / 50~60 Hz) has to be applied to this AC power inlet. Th
8 Connecting the Amplifier Input connections The input connections of the amplifier should be made by connecting the signal from the signal source,
Commentaires sur ces manuels